Trentham Energy

Off grid · 22 November 2026 · 6 min read

ZYC battery review for Australia: who makes the SIMPO 5000 and does it work with your inverter?

By Mick McDonald, Technical Director

A fair read of the ZYC SIMPO 5000 battery: specs, warranty, Victron compatibility, price drivers and its place on the approved list.

A ZYC battery is most likely the ZYC SIMPO 5000, a 51.2 volt, 5.12 kWh lithium iron phosphate rack module made by ZYC Energy Co., Ltd. of Shenzhen, China, and sold in Australia through distributors. Its Australian warranty is 10 years, it is on Victron's list of batteries tested with its inverters, and a tracker of the Clean Energy Council list shows it approved until 1 August 2027. This review is drawn from ZYC's own warranty and datasheet, Victron's compatibility notes and the approved list. If you have a ZYC battery or a quote for one, we're glad to look at it.

Who makes ZYC batteries?

ZYC Energy Co., Ltd. ZYC's Australian warranty, dated 21 August 2024, gives a head office address in Pingshan, Shenzhen, and is issued jointly by ZYC and Guangzhou Great Power Energy Storage Technology Co., Ltd. AC Solar Warehouse describes Great Power as a large battery manufacturer with several production bases, and having a second company named on the warranty is a point in ZYC's favour.

AC Solar Warehouse describes itself as an authorised ZYC distributor for Australia and New Zealand, with warehouses in several capitals including Melbourne. ZYC's own site lists three products: the SIMPO 5000 for homes and small systems, the SIMPO HV high voltage tower, and the SIMPO Pro for commercial sites. For off grid houses running a 48 volt inverter charger, the SIMPO 5000 is the relevant one, so it is the focus here.

What are the ZYC SIMPO 5000 specs?

From ZYC's datasheet:

  • 51.2 V nominal, 100 Ah, 5.12 kWh usable
  • lithium iron phosphate cells, prismatic
  • 100 A maximum discharge, 150 A peak for 5 seconds
  • CAN or RS485 communication, or no communication
  • charging from 0 to 55°C, discharging from minus 20 to 55°C
  • 44 kg, 19 inch rack format, with a built in circuit breaker
  • up to 80 modules in parallel

Those are ordinary figures for a 5 kWh rack module, and in line with the PowerPlus modules covered in our PowerPlus range guide. One thing to note: the datasheet's European warranty line says 60% performance at 10 years, while the Australian warranty document says 70%. For an Australian owner, the Australian warranty is the document that counts.

What is the ZYC battery warranty in Australia?

Ten years against defects, and a performance warranty that the battery keeps 70% of its usable energy for 10 years or until it has delivered 15.36 MWh of throughput, whichever comes first. The warranty starts on the installation date, or six months after manufacture if that is earlier.

The conditions are worth reading before you buy:

  • it must be bought from ZYC or an authorised reseller in Australia, and a battery bought overseas isn't covered
  • it must be installed within one month of purchase
  • it is warranted for daily cycling as an energy storage system
  • a defect must be reported to ZYC or a ZYC partner within 14 days of the owner becoming aware of it
  • temperatures above 55°C or below minus 10°C are excluded, as is damage caused by the inverter or charger
  • ZYC may ask for photos of the installation and the system data

The 15.36 MWh figure is roughly 3,000 full cycles of one 5.12 kWh module. A bank that is too small for the house and is cycled hard every day will reach that before ten years; a bigger bank cycled gently won't. That is a design point, not a criticism, and every throughput warranty works the same way. Our guide to how much battery an off grid house needs covers sizing with that in mind.

Is the ZYC battery compatible with Victron?

Yes, on Victron's terms. Victron lists ZYC Energy among batteries known to have been tested, on a page last updated 11 June 2026. Victron says it is essential to connect the battery to the BMS CAN port of a GX device, at 500 kbit/s, and that the solar charge controllers must also be connected to the GX so the battery can set charge currents and voltages.

Victron's notes also give minimum battery numbers per inverter: for example two SIMPO 5000 modules for a MultiPlus 48/5000/70 in an off grid single phase system. And ZYC battery firmware can be updated through Victron's VRM portal, though Victron advises telling the people on site first, because an update on a remote off grid system isn't risk free.

ZYC's datasheet also gives battery counts for SMA Sunny Island, Studer and Deye inverters, so compatibility goes beyond Victron. Always check the current list for your exact inverter model rather than a brand name.

Is the ZYC SIMPO 5000 on the approved battery list?

According to WhySolar's tracker, which reads the Clean Energy Council approved list, the SIMPO 5000 was approved on 1 August 2024 and is listed until 1 August 2027, with ZYC Energy Company Limited as the certificate holder. Check the official list again before installation, because listings change.

For the federal battery discount, the Clean Energy Regulator requires a battery on that list and an accredited installer, and says an off grid battery must be on a dwelling that is lived in. Sheds and bore pumps don't qualify.

What decides the price of a ZYC battery system?

We don't quote ZYC prices, and a module price on its own says little about what a working system costs. What moves the total:

  • how many modules the house and the inverter need, including Victron's minimum count
  • the cabinet or rack, busbars and breakers
  • the inverter charger and its communication link
  • whether the battery discount applies to your site and battery size
  • the installer's design, commissioning and the distance to site

Trade offs worth weighing

On paper the SIMPO 5000 is a sensible module: a known cell maker behind the warranty, a proper tested link to Victron, and a large parallel limit. The things to weigh are local support and the warranty's conditions. ZYC's support runs through its distributors and partners, and its own claims address is in Shenzhen, so ask your installer who handles a claim in Victoria and how quickly. The 14 day reporting window is short for an off grid owner who doesn't watch the monitoring, so a system that reports to VRM is worth having.

Safety: an owner can read the battery status on the inverter screen or app and keep the cabinet area clear, dry and ventilated. The module breakers, DC cabling, communication link and any firmware or setting change are work for a licensed electrician.

Mick McDonald

Technical Director, Trentham Energy

Questions about your own system? Call 1300 3458 00 or send us a message.

Ready to talk about your place?

Send us a recent power bill and your address. We will come back with a right sized design and a straight answer. No pressure, no oversized quote.